Transcend TS32GCF133 Datasheet download pdf (Page 29)

133X CompactFlash Card

Transcend Information Inc.

Notes: 1) All timing measurement switching points (low to high and high to low) shall be taken at 1.5 V.

2) All signal transitions for a timing parameter shall be measured at the connector specified in the

measurement location column. For example, in the case of tRFS, both STROBE and –DMARDY

transitions are measured at the sender connector.

3) The parameter tCYC shall be measured at the recipient’s connector farthest from the sender.

4)The parameter tLI shall be measured at the connector of the sender or recipient that is

responding to an incoming transition from the recipient or sender respectively. Both the incoming

signal and the outgoing response shall be measured at the same connector.

5)The parameter tAZ shall be measured at the connector of the sender or recipient that is driving

the bus but must release the bus the allow for a bus turnaround.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 78 79

No comments

Transcend TS32GCF133 Datasheet Page 29