Transcend TS0MFLRD6E Datasheet download pdf (Page 6)

Driver Installation for Windows XP, Linux Kernel 2.4 or Later

No driver is needed. Turn off the computer and refer to Hardware Setup below to install the

Internal 6-in-1 Card Reader into your PC.

Hardware Setup

1. Install the Internal 6-in-1 Card Reader into an available 3.5” drive bay.

2. Find the layout of the USB pin-header in the owner’s manual of your motherboard.

3. If the layout of the USB pin-header is as shown below, it matches the default setting

of the USB connector.

 If the layout of the USB pin-header is not as shown above, skip step 4 and go

directly to step 5.

4. Plug the USB connecter of the Internal 6-in-1 Card Reader into the USB

pin-header on the motherboard, with the red wire seated in pin 1 or pin 6. Hardware

setup is complete.

Pin 1: USB Power

Pin 2: USB -

Pin 3: USB +

Pin 4: GND

Pin 5: NC/USBOC

Pin 6: USB Power

Pin 7: USB -

Pin 8: USB +

Pin 9: GND

Pin 10: NC (No pin)

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

No comments

Transcend TS0MFLRD6E Datasheet Page 6